Announcement

Collapse
No announcement yet.

Motor Guide mount "lift assist"

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Motor Guide mount "lift assist"

    FYI, Robbie Patterson at Propeller Dynamics (next to Sandersons) has invented a system to lessen the effort needed to deploy and stow bow mount Motor Guide trolling motors. It works equal to or better than the Minnkota lift assit mount.
    804-706-1847

    I installed it on my Motor Guide this week. I have the black anodized model.
    One goes on each side of the mount.
    This is the stainless steel model:

    Last edited by Wayne P.; 11-18-2012, 08:54 AM.

  • #2
    Thanks Wayne. I've been following the thread on bbc as well. Gonna get this setup since getting old sux. Thanks for the info
    Crank That Jank!
    sigpic

    Comment


    • #3
      What was the cost of the mount/labor?? In your opinion, is it worth the money?? Also, how long did it take to install?? Thanks..
      Nitro 901 CDX w/Mercury 200 EFI dual 8' Power Poles
      TFO Rods Pro Staff
      TRC Covers Pro Staff
      Zeko Shoes Pro Staff

      Comment


      • #4
        I installed it. The parts are 59.99 plus tax for the black model. $119.99 for the stainless steel kit.

        Robbie and another person in the area do the installs, you have to check with Robbie for the installation price.

        It may not be "worth the money" to the young guys, but is definately worth it to the old guys.

        I got direct instructions from Robbie in minute detail and it took me about 45 minutes to install.

        This is the one I did with the motor deployed showing the piston completely compressed. No way can you do that or even budge the piston by hand. It is really heavy duty way beyond the ones like that on boat hatches or even auto rear doors.

        Comment

        Working...
        X